Was this helpful?
Acoustimass® 16 Series II home entertainment speaker system | Setting up your product
To connect the components of your system:
- Connect the multi-pin plug on the audio input cable to the Input jack on the bas module. Tighten the two thumbscrews to secure the connection
- On the other end of the audio input cable, connect each labeled wire pair to the corresponding jacks on the receiver
Tip: Be sure to match the + to - markings on the wire pairs to the corresponding terminals on the receiver - If the receiver has a subwoofer jack (sometimes labeled SUB or LFE), connect it to the RCA plug of the audio input cable
- Connect the speaker cables from each speaker to the OUTPUTS TO CUBE SPEAKERS jacks on the bass module
- Connect the power cord from the bass module to an AC (mains) outlet
Determine where to place your product.
For speaker placement suggestions, see Speaker placement and positioning.Receiver Settings
| Speaker Channels | Speaker Size Setting |
|---|---|
| All Speakers | Large or Full Range |
| Subwoofer | On or Yes |
| Crossover Frequency | 80 Hz or lowest setting |
Using in-wall speaker wiring.
Note: Due to the variety of state and local building codes concerning in-wall wiring, the wiring supplied with Bose systems may or may not be acceptable for in-wall installations. Check local codes for details.If your room has speaker wires installed in the walls, the accessory Adapter Kit for In-Wall Speaker Wires is available to connect to your existing speaker wires
.png)
