Was this article helpful?
Setting up your product | Acoustimass® 3 series V speaker system
To connect the components of your system:
- Connect one end of the speaker cable to your receiver by matching the labeled pairs to the corresponding jacks on the receiver
(Tip: On each pair, be sure to match the wires marked + and - to the terminals marked + and - on the receiver) - Connect the other end of the speaker cable to the INPUT FROM RECEIVER OR AMPLIFIER section on the bass module
(Tip: On each pair, be sure to match the wires marked + and - to the terminals marked + and - on the receiver) - On the bass module, connect speaker wire from the OUTPUT TO CUBE SPEAKERS section to your cube speakers
(Tip: While facing the listening area, the left speaker should be to your left and the right speaker to your right)
Determine where to place your product.
For speaker placement suggestions, see Speaker placement and positioning.
Receiver Settings
| Speaker Channels | Speaker Size Setting |
|---|---|
| All Speakers | Large or Full Range |
Using in-wall wiring.
Due to the variety of state and local building codes concerning in-wall wiring, the wiring supplied with Bose systems may or may not be acceptable for in-wall installations. Check local codes for details.
.png)
