Loading
Acoustimass® 3 stereo speaker system | Setting up your product
acoustimass®-3-series-v-speaker-system
Acoustimass® 3 series V speaker systemSold from 2015 - 2017

Acoustimass® 3 stereo speaker system | Setting up your product

To connect the components of your system:

  1. Connect one end of the speaker cable to your receiver by matching the labeled pairs to the corresponding jacks on the receiver
    (Tip: On each pair, be sure to match the wires marked + and - to the terminals marked + and - on the receiver)
  2. Connect the other end of the speaker cable to the INPUT FROM RECEIVER OR AMPLIFIER section on the bass module
    (Tip: On each pair, be sure to match the wires marked + and - to the terminals marked + and - on the receiver)
  3. On the bass module, connect speaker wire from the OUTPUT TO CUBE SPEAKERS section to your cube speakers
    (Tip: While facing the listening area, the left speaker should be to your left and the right speaker to your right)

Determine where to place your product.

For speaker placement suggestions, see Speaker placement and positioning.

Receiver Settings

Speaker ChannelsSpeaker Size Setting
All SpeakersLarge or Full Range

Using in-wall wiring.

Due to the variety of state and local building codes concerning in-wall wiring, the wiring supplied with Bose systems may or may not be acceptable for in-wall installations. Check local codes for details.

Was this helpful?

YES
NO
START A REPAIR OR REPLACEMENT
Need Help?
Need further assistance? We’re here to help.
Loading
Acoustimass® 3 stereo speaker system | Setting up your product