Was this helpful?
ADAPTiQ system setup and deactivation | CineMate® 1 SR digital home theater speaker system
To run the ADAPTiQ audio calibration system:
Before you begin, be sure the speakers are connected placed where you want them.
- On the remote control, press the Power button to turn on your system
- Put the ADAPTiQ headset on your head. (Tip: Be sure the L and R letters on the headset are above your left and right ears)
- On the left side of the soundbar, slide open the cover to access the ADAPTiQ panel
- Plug in the ADAPTiQ headset to the ADAPTiQ jack. The light on the soundbar glows green and the calibration process begins (Tip: Press the ADAPTiQ button to scroll through the available languages, then press Vol + to select a language)
- Follow the voice prompts to calibrate your system
- Once complete, unplug the headset and slide the panel cover back in place
To turn off the ADAPTiQ audio calibration:
Note: This process erases the current ADAPTiQ audio calibration settings. To enable ADAPTiQ after, restart the audio calibration process.
- Power on your system
- On the left side of the soundbar, slide open the cover to access the ADAPTiQ panel
- Plug in the ADAPTiQ headset to the ADAPTiQ jack
- Hold the ADATPiQ button for about 10 seconds until you hear "ADAPTiQ has been set to its original factory settings"
- Unplug the AdaptIQ headset and replace the panel cover
.png)
