F1 Model 812 Flexible Array loudspeaker | Setting up your product

Setting up your system:

• Powering on or off:
  1. On the back of the system, push the power switch to the desired ON or OFF position
• Connecting sources:
  1. INPUT 1 (Use for microphone or line level sources)
     1. Set the SIGNAL INPUT switch for the source:
        1. Choose MIC if connecting a microphone
        2. Choose LINE LEVEL if connecting a mixer or audio playback device
     2. Connect the source using a 1/4" or XLR cable
        1. Note: The Input 1 jack is a combination jack that accepts 1/4" or XLR plugs
     3. If the source device has a volume control, adjust it to the desired level
     4. Adjust the system's VOLUME control knob to the desired level
        
        Note the SIGNAL / CLIP indicator (Green = Signal present; Red = Signal clipping; Off = No signal present of low signal level)
  
  
• INPUT 2 (Use for line level sources)
  1. Connect the source the RCA or 1/4" input
  2. If the source device has a volume control, adjust it to the desired level
  3. Adjust the system's VOLUME control knob to the desired level
     
     Note the SIGNAL / CLIP indicator (Green = Signal present; Red = Signal clipping; Off = No signal present of low signal level)
• SYSTEM section settings:
  1. POWER FAULT: Indicator LED showing system status (Blue = On; Red = Fault)
  2. LIMIT: Indicator LED lights when the system is limiting audio
  3. FRONT LED: Choose the info displayed by the front LED in the speaker grille:
     1. POWER allows the front LED to indicate the system power status
     2. LIMIT allows the front LED to indicate when the system is limiting audio
     3. OFF disables the front LED
  4. EQ: Use this switch to choose the desired output equalization:
     1. FULL RANGE allows the speaker to function without a high-pass filter
     2. WITH SUB engages a high-pass filter for use with the F1 subwoofer
  5. LINE OUTPUT: Balanced XLR line output that provides a mix of Inputs 1 & 2. Use this to send audio to another system, including a daisy-chain of F1 systems
• Mounting the speaker:
  1. The bottom of the speaker includes an adapter for mounting on a tripod speaker stand that has a 35 mm pole
  2. For information on mounting the system on the F1 subwoofer, see Mounting your product on a stand

Connect audio devices to your product.