Was this helpful?
Acoustimass® 6 Series II home cinema speaker system | Setting up your product
To connect the components of your system:
- On the audio input cable, connect each labeled wire pair to the corresponding jacks on the receiver
Tip: Be sure to match the + to - markings on the wire pairs to the corresponding terminals on the receiver - Connect the plugs at the end of the input cable to the INPUT FROM RECEIVER OR AMPLIFIER jacks on the bass module
(Tip: The black plugs connect to the L and R jacks; the gray plugs connect to the C, LS, and RS jacks) - Connect the speaker cables from each speaker to the OUTPUTS TO CUBE SPEAKERS jacks on the bass module
Determine where to place your product.
For speaker placement suggestions, see Speaker placement and positioning.Receiver Settings
In the receiver settings, look for the settings below. If avaialble, set them as shown.- Front left/right speaker size: Large
- Center speaker size: Small
- Rear left/right speaker size: Large
- Sub: Off
- LFE: On
- Crossover frequency: 200 Hz