Was this helpful?
Resetting your product | VideoWave® III entertainment system - 55''
Do you want to reset your product or restore its default settings?
- Reset: A reset corrects minor processors errors. Unless indicated otherwise, product settings are not lost during a reset.
- Restore factory settings: This resets your product to its factory default configuration. Unless indicated otherwise, all settings are cleared and reverted to their original out-of-box state. After, your product can be configured as if it were being setup for the first time.
Reset your control console and display panel by following these steps:
- Turn the control console off
- On the control console, press and hold Power for five seconds
The red LED on the control panel will turn off - Release the Power button
- Press Power again, the system will reboot
- Retest the system
Reset the SoundTouch adapter.
SoundTouch settings are not lost during a reset.
- On the back of the system console, disconnect the SoundTouch adapter from the Bose link and USB jacks.
- Wait 1 minute, then reconnect the adapter.
- Once the light glows solid on the adapter, resume normal use.
To restore the factory default settings:
Note: With the exception of the ADAPTiQ audio calibration settings, this reset erases all settings and returns your system to its default out-of-box state.
- Power off your system.
- On the back of the system console, disconnect the power cord.
- On the front of the system console, simultaneously press and hold the Source and the Volume - buttons and, while holding them, reconnect the power cord.
- Continue holding the buttons until the Bose logo appears twice on the TV screen.
- Re-pair the remote control with your system. For more info, see Pairing the remote control to your system.
Restore the factory default settings of the SoundTouch adapter.
- Power on your Bose system
- On the back of the system console, disconnect the SoundTouch adapter from the Bose link jack
- If connected, disconnect the Ethernet cable from the adapter
- On the back of the adapter, press and hold the Control button and, while holding it, reconnect the Bose link cable to the system console
- After about 5 seconds when the light on the adapter begins blinking white, release the Control button
- Wait until the light on the adapter glows solid amber
Tip: While resetting, the light will change colors and patterns for up to 4 minutes - If you disconnected an Ethernet cable in step 3, reconnect it.
.png)
