Was this helpful?
Resetting your product | CineMate® 120 home theater system
Do you want to reset your product or restore its default settings?
- Reset: A reset corrects minor processors errors. Unless indicated otherwise, product settings are not lost during a reset.
- Restore factory settings: This resets your product to its factory default configuration. Unless indicated otherwise, all settings are cleared and reverted to their original out-of-box state. After, your product can be configured as if it were being setup for the first time.
To reset your system by following these steps:
- Turn the system off.
- Unplug the control center from the power outlet.
- Unplug the Acoustimass module power cord from the power outlet./li>
- Wait 30 seconds.
- Reconnect the Acoustimass module power cord.
- Reconnect the control center power cord.
To reset the system console.
- Turn the system off.
- Unplug the power cord from the back of the system console or from the power outlet.
- Unplug the cables connected to the Speaker Connections jacks on the back of the system console.
- Wait 30 seconds.
- Reconnect the cables to the Speaker Connections jacks on the back of the system console.
- Reconnect the power cord for the system console.
To reset the optional SoundTouch adapter accessory:
- On the back of the system console, disconnect the SoundTouch adapter from the Bose link jack.
- Wait 1 minute, then reconnect the adapter.
- Once the light on the adapter glows solid, resume normal use.
To restore your system to the factory settings:
This reset erases all settings and returns your product to its default out-of-box state. If a SoundTouch adapter is connected, it must be reset separately.
- On the remote control, press the System button. The system menu will appear in the display on the front of the Bose system console.
- Scroll down to select 16 FACTORY RESET.
- Press the 5 button to confirm.
- Press EXIT to exit the menu.
To restore the factory default settings of the optional SoundTouch adapter accessory:
- Turn on your Bose system.
- On the back of the system console, disconnect the SoundTouch adapter from the Bose link jack.
- If connected, disconnect the Ethernet cable from the adapter.
- On the back of the adapter, press and hold the Control button and, while holding it, reconnect the Bose link cable to the system console.
- After about five seconds when the light on the adapter begins blinking white, release the Control button.
- Wait until the light on the adapter glows solid amber
Tip: While resetting, the light will change colors and patterns for up to four minutes. - If you disconnected an Ethernet cable in step 3, reconnect it.
.png)
