Loading
Connecting a ToneMatch mixer | L1® Model 1S system
l1®-model-1s-system
L1 Model 1S with B2 Bass ModuleSold from 2012 - 2021

Connecting a ToneMatch mixer | L1® Model 1S system

Connect a T1 ToneMatch audio engine by following these steps:

  1. Connect any and all sources (instruments or microphones) to the inputs on the T1
  2. Connect one end of a TRS cable into the "Master" output on the T1
  3. Connect the other end of this cable into the Channel 3 input on the power stand
  4. Set input levels on the T1 and the power stand as normal. For information on setting input levels, see Gain Staging and Setting Input Levels

Connect a T1 ToneMatch audio engine by following these steps:

The ToneMatch port on your mixer and L1 power stand passes both power and audio.
  1. To avoid potential popping sounds while setting up, power off both the L1 power stand and ToneMatch mixer
  2. Connect a ToneMatch cable from the ToneMatch jack on the back of your mixer to the ToneMatch jack on the L1 power stand
  3. Power on your mixer
  4. Power on the L1 system.

Was this article helpful?

YES
NO
START A REPAIR OR REPLACEMENT
Loading
Connecting a ToneMatch mixer | L1® Model 1S system