Was this helpful?
L1 Model 1S with B2 Bass Module | Setting up your product
To connect the components of your system:
- Set the power stand vertically, then grasp one leg and rotate it outward as far as it will go: The other legs will rotate outward at the same time
- Lay the power stand flat
- Slide the lower extension into the power stand. (Tip: Be sure the power stand legs are fully extended or the extension will not fit)
- Slide the guide on the back of the upper speaker array into the channel on the back of the lower extension, then lower the speaker array until it sits flush on the extension
- Connect a power cord from the power stand to an AC (mains) outlet
- Connect the bass module cable from the power stand to the bass module. (Tip: Insert the cable, then rotate it clockwise to lock it in the jack. You should feel a soft click when connected)
Connect a T1 ToneMatch audio engine by following these steps:
The ToneMatch port on your mixer and L1 power stand passes both power and audio.- To avoid potential popping sounds while setting up, power off both the L1 power stand and ToneMatch mixer
- Connect a ToneMatch cable from the ToneMatch jack on the back of your mixer to the ToneMatch jack on the L1 power stand
- Power on your mixer
- Power on the L1 system.
.png)
