Loading
Connecting a ToneMatch mixer | L1™ Model II system
l1™--model-ii-system
L1™ Model II System with ToneMatch™ portSold from 2007 - 2021

Connecting a ToneMatch mixer | L1™ Model II system

Connect a T1 ToneMatch audio engine by following these steps:

The ToneMatch port on your mixer and L1 power stand passes both power and audio.
  1. To avoid potential popping sounds while setting up, power off both the L1 power stand and ToneMatch mixer
  2. Connect a ToneMatch cable from the ToneMatch jack on the back of your mixer to the ToneMatch jack on the L1 power stand
  3. Power on your mixer
  4. Power on the L1 system.

Was this article helpful?

YES
NO
START A REPAIR OR REPLACEMENT
Loading
Connecting a ToneMatch mixer | L1™ Model II system