Was this article helpful?
Wall Mounting the Soundbar | Bose Lifestyle Ultra Soundbar
The Soundbar Wall Bracket accessory comes with a quick-start guide and a mounting template.
- Open the two-sided template. Each side shows two templates. There are four templates shown in total.
- Align the rubber feet on the bottom of your soundbar with the brackets printed in the same position on the template. Note which pair of brackets on the template match your soundbar.
- Place the template on your wall, centered below the TV, then slide the template up behind the TV so bottom of the shaded area is in line with the bottom edge of your TV.
This placement is important to ensure the wire channel cover hides the cables going behind your TV. - Use a level to ensure the template is straight, then tape the template to the wall.
- Based on the bracket positions identified in step 2 that match your soundbar, mark the two pairs of holes through the template and onto the wall.
The wire channel base can be attached with screws or with the included double-sided tape. If using the tape, you do not need to drill the two holes for the wire channel. - Drill the holes you marked, insert wall anchors for any holes that are not on a wall stud, and attach the brackets to the wall.
- For the wall bracket, start with the smaller 1/8” drill bit. If any hole is on a stud, you can use the 1/8” hole you made. For any holes where you do not hit a stud, widen the holes with a 11/32” drill bit.
- For the wire channel, start with the smaller 3/32” drill bit. If you hit a stud, you can use the 3/32” hole you made. If you do not hit a stud, widen the hole with a 3/16” drill bit.
- Use the smaller plastic anchors for the wire channel.
- Use the larger T-shaped metal anchors for the wall bracket. To insert the anchor, fold the two legs together, then push it into the wall. Next, insert the red push pin into the anchor to open it behind the wall. Then remove the push pin.
- Use the smaller pointed screws for the wire channel.
- Use the larger pointed screws to attach the wall brackets the wall.
- Peel off the rubber pads from the bottom of the soundbar to expose the mounting points.
- Connect the power cord and HDMI cable to your soundbar.
The right-angled adapter included with the wall bracket kit is not needed for the installation of the Lifestyle Ultra Soundbar. - Attach the brackets to your soundbar.
- Align the mounting points on the soundbar to the holes on the brackets.
- Use the small flat screws to attach each bracket to your soundbar.
- Use a screwdriver to securely tighten screws.
- Run the cable over the wire channel base, then press the wire channel cover on top of the base.
.png)
