Was this helpful?
ADAPTiQ system setup and deactivation | Lifestyle® T10 home theater system
To run the ADAPTiQ audio calibration system:
Before you begin, be sure the speakers are connected placed where you want them.
- On the system console, press the Setup button. (Tip: If the system menu does not appear on your TV, be sure the correct TV input is selected)
- On the remote control, scroll down to select ADAPTiQ, then press the OK button
- Follow the on-screen instructions to calibrate your system
To turn off the ADAPTiQ audio calibration:
Note: Your system software must be version 01.06.00 or later. For more info, see Checking the software or firmware version.
- On the system console, press the Setup button. (If the system menu does not appear on your TV, be sure the correct TV input is selected)
- Use your remote to select ADAPTiQ
- Press the Right arrow button to view the ADAPTiQ options
- Select Enable/disable, then press OK
- When prompted to disable ADAPTiQ, select Yes, then press OK
Tip: The ADAPTiQ audio calibration settings are disabled but not erased. You can re-enable them at any time - Press the Exit button to close the menu
.png)
