Loading
Accessing and using Diagnostic Mode | Bose Solo TV Speaker
bose-solo-tv-speaker
Bose Solo TV SpeakerSold from 2012 - 2015

Accessing and using Diagnostic Mode | Bose Solo TV Speaker

To enter diagnostic mode:

With the system on, press and hold the on/off button on the remote for 10 seconds. The LED on the system will blink repeatedly while the button is held. After 10 seconds, release the button and note the system LED blink pattern, which will continually repeat until the power button is pressed, (Note: If the LED goes out, the system did not receive the signal from the remote for the full 10 seconds.)
  • The LED alternates red and green quickly: audio signal detected
  • The LED blinks red quickly: no audio signal detected
  • The LED is solid red: digital zeros received

Was this article helpful?

YES
NO
START A REPAIR OR REPLACEMENT
Loading
Accessing and using Diagnostic Mode | Bose Solo TV Speaker