Was this helpful?
Connecting to power | T4S ToneMatch® mixer
Using the ToneMatch port with compatible L1 power stands:
If the power stand for your L1 system has a ToneMatch connection, you can connect power and audio to your ToneMatch mixer with a single connection: Just connect a ToneMatch cable from the Power / Main Out R jack on the mixer to the ToneMatch port on the L1 power stand.
(Tip: To avoid potential popping sounds when powering on, connect the cable before powering on the L1 system and turn up the L1 volume after powering on.)
(Tip: To avoid potential popping sounds when powering on, connect the cable before powering on the L1 system and turn up the L1 volume after powering on.)
Using the power supply:
Note: A power supply is included and required for T8S ToneMatch mixers. T4S ToneMatch mixers can be powered by the ToneMatch port on compatible L1 system power stands, or by a power supply, which is available as an optional accessory for T4S ToneMatch mixers.
To connect a power supply to your mixer:
To connect a power supply to your mixer:
- Plug in the power supply cable to the power port on the back of the mxer
- Connect the the female end of the AC power cord to the power supply
- Connect the male end of the AC power cord to an AC power outlet