Loading
Understanding LED indicator status lights and information | VideoWave® III entertainment system - 55''
videowave®-iii-entertainment-system---55''
VideoWave IIISold from 2013 - 2015

Understanding LED indicator status lights and information | VideoWave® III entertainment system - 55''

SoundTouch Wireless Adapter LED Status Indicator

\"Back
\"LED

Off

LED State: Off

Description: The adapter is unpowered, connected via Ethernet or the network is disabled

\"LED

LED State: White (blinking fast)

Description: The adapter is attempting to connect to a Wi-Fi network

\"LED

LED State: White (slow flash)

Description: The adapter is downloading a firmware update

\"LED

LED State: White

Description: The adapter is connected to a Wi-Fi network

\"LED

LED State: White (solid 3 sec, double-flash, repeat)

Description: The adapter is installing a firmware update

\"LED

LED State: Amber (blinking)

Description: The adapter failed to connect to Wi-Fi / network error

\"LED

LED State: Amber (blinking fast)

Description: The adapter has a firmware error

\"LED

LED State: Amber (solid)

Description: The adapter is in setup mode broadcasting its \"Bose SoundTouch Wi-Fi Network\"

Note: Adapters produced after DOM 4286 have a clear plastic lens in front of the indicator allowing the light from the LED to be seen more easily. Adapters produced before this DOM may require looking directly in to the hole to to see the LED.

VideoWave System Status Indicators

Console LEDMonitor LEDDescriptionRelated Information
OffOffNo Power or system is off (Standby)
RedRedSystem is in network standby
Blinking Green*Blinking Green*System is starting up -or- System Information Screen is upProduct will not turn on
System continuously reboots
GreenOffSystem is on
Blinking Red (5 on, 1 off)**RedRemote batteries are low
Blinking Amber (5 on, 1 off)**RedUnify has not completedConnecting other devices to your system
Blinking Amber (5 on, 1 off)RedSystem is off and device has been removed from the console
RedAlternating Green/RedThermal shutdown has occurred***
Blinking Green or Solid GreenBlinking RedNo Power to AV Monitor
GreenGreenVideo Mute enabledAdjusting Video Mute
AmberRedSystem powering down -or- System off and charging iPodThe LED will be amber for about 15 seconds while the system powers down
Blinking Red (5 on, 1 off)RedUnify process complete but no available devices connected
GreenRedA/V monitor cable needs reseating or control console requires updateUpdating the software or firmware of your product

*Note: If this state persists indefinitely during boot then there may be a console failure
**Note: Occurs for a 30 seconds after system turned off (standby)
***Note: This LED pattern will persist even after the conditions that led to the thermal shutdown have changed.

Was this article helpful?

YES
NO
START A REPAIR OR REPLACEMENT
Loading
Understanding LED indicator status lights and information | VideoWave® III entertainment system - 55''