Was this helpful?
Connecting a Wave SoundLink Adapter | Wave® music system
To connect the Wave SoundLink Adapter to a Wave Music System:
Connecting the SoundLink adapter lets you hear all sound from your computer through your Wave system
- If your system software is 02.xx.xx or earlier, insert the included software disc. For more info, see Checking the software or firmware version
- Connect the cable attached to the SoundLink adapter to the Bose link jack on the back of the Wave system
- Place the adapter in a convenient location. It does not need to be within view but if it is to left of your system (as you face it), leave at least 2 inches (5 cm) between it and the system to reduce AM radio interference
- If your system DOM (date of manufacture) is earlier than 9286, you'll need to connect the DC power adapter to the SoundLink adapter. Systems with a DOM of 9286 or later do not need the power adapter. For more info, see Serial number location
- On the SoundLink remote, press the SoundLink/AUX button so the system display shows SOUNDLINK CONNECTING DISCOVERABLE
Tip: If NO SIGNAL appears, see "NO SIGNAL – PRESS PLAY TO CONNECT" message displayed - Lift the antenna on the SoundLink USB key to the vertical position
- Connect the USB key to an available USB input on the computer: The light on the key should begin blinking
- Wait for the computer to detect the device and install drivers, if needed: When the light on the USB key glows solid and a tone is heard from your Wave system, it's connected.
Tip: If the light glows solid but no sound is heard, see Selecting a sound playback device on a computer.
.png)
